- INSTALLATION INSTRUCTIONS -
- NO DRILLING REQUIRED -

FOR BOATS WITH SMOOTH FIBERGLASS UNDER THE LIDS such as Ranger, BOATS WITH EXPOSED METAL CHANNEL UNDER THE LIDS such as Triton, and BOATS WITH SMOOTH METAL UNDERSIDES OF LIDS such as Rebel you can use 3m double sided tape (3m brand Scotch exterior mounting tape #4011T)...red label (not included with package). Clean both surfaces with alcohol, apply tape to the Cook's Tackle System, then to your mounting surface This method is not recommended for underside with carpet or foam padding.

NOTE:* It has been brought to our attention that many people really like our Tackle Storage System, but when it comes to drilling the 11/64" diameter holes, and installing the two #6 screws they are very concerned that the screw heads will be visible. We intentionally downsized the mounting screws to a #6 screw so the head would be small & disappear in the carpet when tightened. If the instructions on the package card are followed this will not be a problem. Pick the carpet fibers out from under the screw head prior to tightening the screws, then as the screws are tightened the rubber backing of the carpet will yield and the fibers will pull over the screw heads concealing them very well. This rubber backing will also seal the screw from any leakage from rain.